10 Hardware Setup
Function of every connector on the COM/VGA/LINE adapter is
described below:
DB1 – VGA Cable Connector
Attach the cable of VGA monitor to this connector.
JACK1 – Line Out Connector
Attach Line-In cable of the external speaker system device to this jack.
J1 – COM1 Connector
Attach COM1 cable to this connector.
JP2 – COM2 Connector
Attach COM2 cable to this connector (this cable is provided by the
mainboard manufacture.)
J2* – Line Out Mainboard End Connector
Attach 4-pins linking cable to this connector. The other end of this cable
is connected to JP9 of the mainboard (this cable is provided by the
mainboard manufacture.)
Note: Use this cable only when your hardware MPEG is installed.
Check with your mainboard supplier for more MPEG information.
To Next Page
Loading...
Need help?
General
