Need help?Do you have a question about the SP Shocker CVO and is the answer not in the manual?
Instructions for assembling the Shocker CVO barrel and using the barrel blocker.
Steps for connecting air, powering on, and adjusting marker velocity.
Safe methods for charging and venting the marker with HPA.
Adjusting magnetic tension, pre-travel, post-travel, and activation lever.
Recommendations for loaders and how to adjust the feedneck.
Adjusting the QEV to control bolt closing force and marker performance.
Step-by-step guide for cleaning and reassembling the bolt system.
Procedures for cleaning and inspecting the ball detents.
Procedures for ASA knob, position, removal, and disassembly.
Removing and servicing the regulator's spring platform and piston.
Inspecting and servicing the regulator base, seals, and reassembly.
Procedures for removing and reinstalling the grip frame.
Servicing pilot valve o-rings, components, and reassembly.
Procedures for servicing the bolt control manifold and QEV.
Identifying and fixing common air leaks in the marker.
Addressing issues like first shot drop, paint breakage, and firing failures.
Diagrams and part numbers for the firing can and chamber guide.
Diagrams and part numbers for the main chamber and bolt assembly.
Diagrams and part numbers for valve and bolt control manifolds.
Diagrams and part numbers for the clamping feedneck and barrel.
Diagrams and part numbers for latch assembly and detent cover.
Diagrams and part numbers for the regulator piston and spring guide.
Diagrams and part numbers for the regulator base and springs.
Diagrams and part numbers for the bottom line ASA and trigger.
Diagram and part numbers for the grip frame assembly.
General| Brand | SP |
|---|---|
| Model | Shocker CVO |
| Category | Paintball equipment |
| Language | English |
To Next Page