Spa Sciences NasalFresh MD - Getting Started

To Next Page

To Previous Page

4 | NasalFreshMD

Getting Started

Your NasalFresh MD comes substantially assembled. To

complete the assembly, detach the Lower Tank from the

Mechanical Module by grasping the Module with one hand

and the Tank with the other and pulling the Tank away from

the Module. Remove contents of the Lower Tank and set

aside. Wash the Nasal Pillows following the instructions

for cleaning on page 7 of this Manual. Attach the 2 Nasal

Pillows to the stems on the Hand Control. Reattach the

Lower Tank. You are ready to begin.

Note: When not using the Device, store the Hose and Hand Control in the compartment

below the Storage Opening of the Mechanical Module. Insert the Hand Control by

lining up the 2 guides below the Activate Button on the Hand Control with the 2

corresponding slots in the Storage Opening.

Charging

NasalFresh MD is rechargeable (no batteries required) and

compatible with USB charging. Charge the Device prior to using it

for the rst time. You will need the USB charging cable (included

with your Device) and a power adapter (wall plug) with a USB port.