8 | NasalFreshMD
Powering Off
Pressing the Power Button a fourth time will turn the Device off.
Using Your NasalFresh MD
Remove the Hand Control from the Storage
Opening and extend the Hose. Run a little
water over the Nasal Pillows to make them
easier to seal against the nose. Holding the
Hand Control in one hand, press the Pillows
up against the nose so they they gently seal
the nostrils (as shown).You should not have
to push the Pillows into your nose to achieve
a seal. The Pillows should rest lightly on the
outer edge of your nostrils while still securing a
seal. If needed, larger and smaller size Nasal
Pillows are available at www.nasalfreshmd.
com. Keep the Nasal Pillows centered and
unblocked in the nose. Do not press hard which can cause the Nasal Pillows to get
blocked against the nasal wall decreasing or stopping the nasal irrigation.
Press the Power Button on the Mechanical Module and select the desired Cleansing
Mode.
To Next Page
Loading...