EasyManuals Logo

Spacelabs 91393 User Manual

Spacelabs 91393
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
www.spacelabshealthcare.com
1-4
XPREZZON
AND QUBE
O
PERATIONS MANUAL
I NTRODUCTION
Flexport System Interface
The Flexport system interfaces integrate data from compatible third-party
peripheral devices (such as ventilators, hemodynamic monitors, and pulse
oximeters) into Spacelabs Healthcare monitors.
Flexport interfaces provide current numeric data, alarm information, and selected
waveforms. All of the data communicated to the Spacelabs Healthcare monitor is
available at network locations, providing alarms and centralized displays. Contact
your Spacelabs Healthcare sales representative for additional information.
Parameter Modules
Use parameter modules with a Spacelabs Healthcare monitor to monitor clinical
parameters such as electrocardiography (ECG) and noninvasive blood pressure
(NIBP). Each module ships with default settings for alarms and various other
operational settings, which can be adjusted to meet the needs of your patients or
comply with your hospital’s protocol.
Note:
Do not operate electronic devices (for example, portable communication
transmitters, cellular telephones, personal computers, electronic toys, and other
medical devices) within one meter (3.5 feet) of the patient, patient leads, or
associated monitoring equipment until evaluated by the biomedical engineering
staff. Electromagnetic interference may occur when using these devices.
Caution:
Use of the monitor is restricted to one patient at a time.
Using multiple instances of parameters such as ECG is not supported.
To install a module
1 Make sure that the locking lever on the module is closed and that the module
is oriented correctly.
2 Insert the module into any open slot in the monitor or module housing.
3 Slide the module into the monitor or module housing until the front of the
module is even with the front of the monitor.
Note:
A soft “click” indicates that the module is locked in place.
To remove a module
1 Disconnect any cable(s) from the front of the module, if necessary.
2 Push the left side of the locking lever.
3 Hook your finger through the open locking lever.
4 Pull the module out of the slot.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Spacelabs 91393 and is the answer not in the manual?

Spacelabs 91393 Specifications

General IconGeneral
BrandSpacelabs
Model91393
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals