SpaceraiL LEVEL 1 - Connect Rails A, G, I

Spacerails, LLC. All rights reserved. Spacerails.com Page 9
CONNECT RAILS A, G, AND I
Use the following illustrations and pictures as references for attaching the Rails to the structure:
Step 1: Connect both A Rail sections between the Loop and the back bottom corner of Shaft A.
Step 2: Connect both G Rail sections between the entrance of the loop and the front section of the Split.
Step 3: Connect both I Rail sections between the bottom entrance of the elevator and the bottom front corner of Shaft A.
A
B
C
D
E
STEP 1
(A Rail)
STEP 2
(G Rail)
STEP 3
(I Rail)
STEP 1
A Rail)
STEP 2
(G Rail)
STEP 3
(I Rail)
A
B