2
POWER PRO ELECTRIC CONTROL OPERATION
Spacesaver electric systems may include all or some of the many Spacesaver safety devices offered for operator
protection. The intent here is to describe the proper use of the electric controls. This document, coupled with your on
site training, will provide the means for the safe, efficient and non-abusive use of the system. Subsequent training of
new personnel is the responsibilty of the area supervisor. This overview of operation and safety features may include
information about options not incorporated into your unique Spacesaver System.
Your role in maintaining the system:
• Bring any problem observed to the attention of a supervisor at once.
• Keep all aisles clear of obstructions.
• Keep the tracks free of any small debris.
SWITCH FUNCTIONS:
The STOP/RESET button will shut carriage travel down softly.
The STOP/RESET button will reset the system after a safety fault.
The STOP/RESET button will cancel a locked aisle condition.
The STOP/RESET button will turn off aisle lights.
The MOVE button will initiate carriage movement.
The MOVE button will turn on aisle lights.
The RECEPTACLE near the base of the switch will accept the power override unit
and the safety override key.
1. Selecting an aisle with the "touch and hold" option:
1.1 Push in and hold an "move" button on either side of the aisle you
wish to open. Carriage movement will cease when pressure is
removed from the button or when the aisle is fully open.
2. Selecting an aisle with the "one touch" option:
2.1 Push in an "move" button on either side of the aisle you wish to
open, until carriage movement begins at any location within the
system. Release the button and the selected aisle will open
automatically. Carriage movement will cease when the aisle is fully
open.
3. Stopping carriage travel:
3.1 All system movement can be stopped at any time by pressing the
"stop" / "reset" button on any carriage.
4. Selecting an aisle with the "touch and hold" manual reset option:
4.1 Aisle selection with this option is identical to #1.
4.2 Once the aisle is fully open the reset lights will blink on either side of
the selected aisle.
4.3 No new aisle selection can be made until the reset button on either
side of the open aisle is pressed, canceling the locked aisle
condition.
Note: The closing of a safety faulted aisle is not possible without the
use of the safety override key. Please see your supervisor for
instructions regarding the safe use of the safety override key.
To Next Page
Loading...
Need help?
General
