6
Spacesaver Corporation
a division of KI
U.S.A.: 1450 Janesville Ave., Ft. Atkinson, WI 53538, (920) 563-5546, 1-800-492-3434, FAX: (920) 563-2702
CANADA: 266 King Street East, Toronto, Ontario M5A 4L5, (416) 360-1022, 1-800-544-3679, FAX: (416) 360-7290
WEBSITE: www.spacesaver.com E-MAIL: ssc@spacesaver.com Copyright © 2000, Spacesaver Corporation. Printed in U.S.A.
REV. 2.0/OP-0040 SSC/EPD 7/04
12.6 If the lock is located on the last carriage, move all carriages closed
to the left and lock to disable any system operation.
12.7 Special locking configurations may be used. Consult your
salesperson.
13. Using the optional remote control interface:
13.1 This feature allows operation of the system from some remote
location.
13.2 A display on the remote indicates the present state of the system.
13.3 Most efforts required to operate the system can be carried out at
the remote station.
13.4 Safety activations and locked aisles cannot be cleared via the
remote control.
14. Using the optional overhead aisle lights:
14.1 Use of the optional aisle lighting usually requires no conscious
effort on you part. These lights will come on when the aisle is
opened or when you enter the aisle.
14.2 The lights will go out automatically shortly after you leave the aisle.
14.3 You may have to turn the lights back on when entering a darkened
aisle. Do this by pressing the "move" button on either side of the
aisle.
14.4 If the lights are not timed to go out automatically upon exiting the
aisle they can be turned off manually by pressing a "reset" button
on either side of the aisle.
15. Using the optional AisleGuard safety system:
15.1 Using this option usually requires no conscious effort on your part.
A request for an aisle will automatically generate a scan of the
open aisle before carriage movement begins.
15.2 Any aisle entry or exit will automatically generate a scan of the
aisle.
15.3 As long as you remain in the aisle no carriage movement is
possible and the "aisle in use" message is displayed along with a
solid red light.
15.4 Upon leaving the aisle system should automatically return to the
"green light" state. If not, check the aisle for an obstruction and
then press the reset button to restore operation.
RECOMMENDED LOADING INSTRUCTIONS:
Do not fully load one side of double-entry shelving without counterbalance weight on the other side.
Begin loading at the lowest shelf.
At no time should the weight differential from one side to the other exceed 50 percent.
To Next Page
Loading...
Need help?
General
