www.spalusa.com
14
Programming
(continued)
The FAN-PWM has 3 default programs for use with the SPAL temperature sen-
sor (FAN-PWM-TS).
Selecting The Desired Preset
1. Hold down PRG button for 5 seconds.
2. FAN will stop running and ‘FAN’ LED will be slowly blinking AMBER.
3. Press PRG button 2 times.
4. ‘FAN’ LED will slowly blink GREEN.
5. Press ENTR button once for Preset 1. ‘STAT’ LED will ash once.
Press ENTR button again for Preset 2. ‘STAT’ LED will ash twice.
Press ENTR button again for Preset 3. ‘STAT’ LED will ash three times.
6. Once desired preset has been reached Press PRG button to exit
programming mode.
Preset 1 has a LOW temp of 170° and a HIGH temp of 185°.
Preset 2 has a LOW temp of 190° and a HIGH temp of 205°.
Preset 3 has a LOW temp of 205° and a HIGH temp of 220°.