14
4
5
MIDDLE POLE
TOP POLE
While maintaining alignment of dimple and trough, bounce middle pole section (5) into top pole
section (4) using a wood scrap as shown until the top pole (4) is aligned with the marked line on
the middle pole (5).
You should have a 3 1/2” (8,9 cm) of overlap when properly assembled.
3.
MARKED LINE
TROUGH
DIMPLE
5
MIDDLE POLE
4
TOP POLE
HOLE
(NOT USED
IN ASSEMBLY)
IMPORTANT!
Align dimple of top pole section (4) into trough
of middle pole section (5) as shown.
MARK LINE
3 1/2”
(8,9 cm)
CAUTION!
WHEN PROPERLY POUNDED
TOGETHER, THE POLE SECTIONS
SHOULD HAVE A 3-1/2” (8,9 CM)
OVERLAP.
Wood Scrap
(not supplied)
To Next Page
Loading...
