Need help?Do you have a question about the SPAN PressureGuard PROTOCOL and is the answer not in the manual?
Describes the components and functionality of the PressureGuard Protocol system, including cover, foam shell, and control unit.
Explains the two powered therapy modes available: FLOAT or ALTERNATING, for patient comfort and pressure management.
Details the purposes for using the PressureGuard Protocol, including prevention and treatment of pressure injuries.
Defines the system as a pressure management system for prevention and treatment of pressure injuries.
Describes the fluid-resistant, vapor-permeable, and cleanable outer layer of the mattress.
Explains the multi-layered inner cover acting as a barrier and air supplier for microclimate management.
Details the lengthwise air cylinders for inflation, flotation, and alternating pressure therapy.
Describes the high-density foam topper with Geo-Matt® design and Safety Edge™ bolsters.
Explains the function of the quiet, energy-efficient control unit with two air compressors.
Details the process of hanging the control unit and connecting its power and air lines.
Explains how to connect the mattress air lines to the control unit, ensuring proper mating and routing.
Describes how to power the unit on and off, and the indicator light behavior.
Explains how to adjust the comfort level based on patient weight and desired immersion.
Details how to toggle between ALTERNATING and FLOAT therapy modes.
Explains the function of the LOW PRESSURE indicator and troubleshooting steps.
Describes the AUTO FIRM mode, its duration, and how it affects other settings.
Explains how to manage the audible alarm for low pressure alerts.
Details the continuous AIR FLOW function and its indicator light.
Discusses the impact of HOB elevation on pressure distribution and recommended limits.
Addresses the use of bed rails based on facility policy and patient assessment.
Outlines specific steps to take for CPR when using the mattress.
Explains system behavior during power loss and recommendations for extended interruptions.
Details how to safely transport a patient using the mattress, including mode selection.
Addresses common patient complaints like 'sinking' and provides explanations/solutions.
Recommends specific types of bed linens and advice on layering.
Provides contact information for repair and service of the control unit.
Lists the required environmental conditions for safe and effective operation.
Details the warranty period and coverage for the PressureGuard Protocol system.
Emphasizes that the system is one part of comprehensive wound care.
Provides detailed instructions for cleaning and disinfecting the mattress covers.
Guides on environmentally responsible disposal of the product according to WEEE compliance.
Explains how to check, clean, and replace the air filter for the control unit.
Offers crucial safety tips for inspecting power cords to prevent hazards like fires.
Outlines procedures for inspecting the mattress cover and components for damage.
Discusses potential interference issues and how to mitigate them.
Lists available replacement parts with their respective catalog numbers.
General| Brand | SPAN |
|---|---|
| Model | PressureGuard PROTOCOL |
| Category | Indoor Furnishing |
| Language | English |
To Next Page
