SpaNet Mini 1 - Wiring Diagram (Mini 2); DIP SWITCHES

V.2005 Page | 3
Wiring Diagram (Mini 2)
Output Ratings
Model
Outlet
Max Current
Output Voltage
Hz
Typical Accessory
SV Mini 2
230V
10A
230-240V AC
50/60
Heat Pump / Stereo
Pump 1
10A
230-240V AC
50/60
Circ / 2-spd or 1-spd Pump
Pump 2
10A
230-240V AC
50/60
1-spd Pump
03/UV
2A
230-240V AC
50/60
Ozone / UV Sanitiser
Pump 3
10A
230-240V AC
50/60
1-spd Pump
Blower
4.5A
230-240V AC
50/60
Air Blower
DIP SWITCHES
The dip switches determine the configuration of pumps connected to the SV Mini controllers. The installer
must correctly configure the dip switches to match the pump(s) connected to the spa controller. The dip
switch bank (illustrated below) has six individual switches. Switches set to the right of the switch bank
(away from the numbers) are in the ON position. Switches set to the left of the switch bank (closest to the
numbers) are in the OFF position. Refer to diagram below for dip switch settings:
SW
Setting
OFF (left)
ON (right)
Notes
1
Not used
-
-
2
Pump 1 Type
Single Speed
Two Speed
Determines if P1 = 1spd/2spd
3
Pump 3 Fitted *
Not Fitted
Fitted
Determines if P3 is connected
4
Not used
-
-
5
Not used
-
-
6
Not used
-
-
* SV Mini 2 models only
NOTE: The dip switches will already be set by your spa manufacturer during production and should not
require adjusting. This information is for reference when installing a new control to an existing spa.