SPC BAAMBA - Page 13

13
EN
6
"HOME" and "POWER"
Flashing blue at same
time
7
Fully charged
"HOME" Sustained
bright blue light
8
Pairing mode "HOME" Flashing blue
Press and hold "HOME" for 6
seconds to go into connection mode.
INDICATOR LIGHT OPERATING GUIDE
(Ref/SKU: 6402S BAAMBA GYRO 4.0)
No. State Display Operation
1
Power Off Lights Off
1. In standby mode, after 5 minutes
the robot will go into sleep mode.
2. In sleep mode, if the state of the
battery is low or the elapsed time is
greater than 8 hours, the robot will
turn off.
2
Power On Red light on
Press "CLEAN" briey and go into
standby mode.
3
Cleaning Green light on
Press "CLEAN" briey and go into
automatic mode
4
Recharge Flashing green
Double click on "CLEAN" and it will
go into recharge mode.
5
Charging Flashing red
6
Error
Flashing red and a
beep
7
Fully charged Lights Off
8
Pairing mode Flashing orange
Press and hold "CLEAN" for 5
seconds until the indicator light
starts to ash orange.