17
Figure 12 Figure 13
Figure 10 Figure 11
Bass Adjustment:
Thethreeverticalbuttonswiththecenterbuttonlabeled“B”allowfor6dBofBASS(low
frequency) adjustment. Your speakers were shipped with the bass set to neutral, result-
ing in 6ohms of impedance. This setting provides the flattest bass frequency response.
If you desire more bass, push the button with the up arrow and the bass will play 3dB
higher and lower the impedance to 4ohms. If you want less bass, push the button
with the down arrow and the bass will play 3dB lower and increase the impedance to
8ohms. This setting provides a more linear bass frequency response. To return to the
neutral setting, push the “B“ button. (See Figure 13) Rememberthatalteringtheimped-
ance affects the number of speakers able to be driven by an amplifier. If multiple pairs of
speakers are to be driven by one amplifier, SpeakerCraft suggests using the lowest out-
put position (the down arrow) until it is determined that the amplifier will operate prop-
erly with the speakers switched to a higher output mode. If you want to safely operate
multiple pairs of speakers, consider purchasing SpeakerCraft S4 or S8 Speaker Selectors.
Thedesiredsettingfortreble,midrangeandbassMUSTbepressedinorderforthespeakertoplay
properly. The tweeter will NOT play if a selection is not made.
IMPORTANT NOTICE
Please read before installation
Bass
Midrange
Treble
To Next Page
Loading...
Need help?
General
