OPERATE
STOP THE ENGINE
1. Release the throttle lever to allow the engine to idle for a
few seconds.
2. Set the switch to the “O” position.
IMPORTANT: Do not put the chainsaw on the ground
when it is still running. For additional safety, Switch
the chainsaw off when not in use or between cuts.
In the event that the ignition switch will not stop the
saw, pull the choke control out and engage the chain
brake to stop the engine. Call service center.
NOTE! When you have finished using the saw,
always relieve the tank pressure by loosening, then
retightening, both tank caps. Allow the engine to cool
before storing.
To Next Page
Loading...
