Spectra 1728/EX & 1738/EX - 21 - Programming Guide
Bold = Default Setting
PGM PROGRAMMING
The PGM Deactivation event can be used as another activation event if the PGM Timer (section [554]) is programmed with a
value other than 000. The PRT1 module uses the same PGM events as the Spectra control panel, please refer to
“Programmable Outputs” on page 7
Section # Decimal Value (000-255) Description Default Value
[554] ___/___/___ seconds (000 = fo llow de activation eve nt) PG M1 TIMER 5 sec.
Section # Event Group # Sub-Group # Partition #
[555] PGM1 Acti vation Event ___/___ ___/_ __ ___/___
[556] PGM1 Deactivation Event ___/___ ___/___ ___/___
CLOCK PROGRAMMING
For example, to enter the date March 26, 2000 you would enter 20 (century), 00 (year), 03 (month), and 26 (day).
Section # Val ue
[557] Year ___/___/___/___ Month ___/___ Day ___/___
SECTION [553]: SERIAL AND PARALLEL PORT SETUP OPTIONS
Option
OFF ON
[1]
Seri al Port N Disabled N Enabled
[2]&[3]
N see table
N see table
N see table
N see table
[4]
Parallel Port N Disabled N Enabled
[5]
Off-l ine Status Ig no re d (paral lel por t onl y) N Disabled N Enabled
[6]
Paper Empty Status Ignored (parallel port only) N Disabled N Enabled
[7]
Printer Fault Status Ignored (parallel port only) N Disabled N Enabled
[8]
Printer Busy Status Ignored (parallel port only) N Disabled N Enabled
Baud Rate Settin gs
[2] [3] APR-PRT1 APR3-PRT1
OFF OFF 1200 baud (default) 2400 baud (default)
ON OFF 2400 baud 9600 baud
OFF ON 9600 baud 19200 baud
ON ON 19200 baud 57600 baud
To Next Page
Loading...
