American English–10
1 609 929 E86 • (02.12) T
Subtraction from Measured Values
By pressing the button 15, the value at the bottom of the display is
deducted from the value stored. In the display, “M–” appears briefly and
then “M”.
If a value is already present in the memory, the new value is subtracted
from the memory contents, however, only when the units of measurement
are in agreement (see Storing/Adding of Measured Values).
Display of the Stored Value/
Display of the Last 20 Measurement Results
By pressing the button for memory recall
14, the value stored in the memory is
displayed. In the display, the memory symbol
“M=” appears.
When the memory content “M=” is shown in
the display, it can be doubled by pressing the
button 16 or set to zero by pressing the
button 15.
In addition, the unit stores automatically the
results of the last 20 measurements. By re-
peated pressing of the button for memory re-
call 14, the measurement results are
displayed in reverse order (the last measured
value first). In the display, the symbol ap-
pears. The counter at the right next to the
symbol shows the numbering of the displayed
values.
The measured values displayed can still be entered into memory by press-
ing the button 16 or the button 15.
Clearing the Measured Value/Memory
By pressing the clear button 12, correction of the last determined
individual measured values in the area, volume, continuous/mini-
mum/maximum and indirect length measuring functions is possible.
By repeated pressing of the clear button
, several individual measured values are
cleared one after the other in the reverse order
of the measurement.
By pressing the clear button in the min-
imum/maximum measuring function, the min-
imum and maximum measured values are
cleared simultaneously.
To clear the memory contents, first press the button 14 for memory
recall until “M=” appears in the display. Then press the clear but-
ton 12; the “M” no longer appears in the display.
The list of the last 20 measurement results can be cleared when first the
button 14 for memory recall is pressed until the symbol and the
counter of the measurements appear. Then press the clear button
12; in the display, no longer appears.
To Next Page
Loading...
Need help?
General
