Spectra Stack - Shipping Bracket

Install the Shipping Bracket Ensure ESD Protection
December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library
5
 Wearastaticprotectionwristbandorgroundingfootstrapwhenever
youhandlecomponentsthathavebeenremovedfromtheir
anti‐staticbags.Connectthewristbandtothestaticprotectionmatorto
othersuitableESDgrounding.
Note: Keepallelectroniccomponentsinanti‐staticbagswhennotin
use.
INSTALL THE SHIPPING BRACKET
Usetheinstructionsinthissectiontoinstalltheroboticsshippingbracket
intheSpectraStacktapelibrarypriortoshipping.
1. Removethetopcov er.
a. Usingasmallscrewdriver,pressdownonthereleaselatchonthe
topofthechassisatthefront.
b. Slidethetop
covertowardsthefrontofthechassisuntilitcontacts
thescrewdriver.
c. Removethescrewdriverandslidethecoverforwardtoreleaseit
fromthechassis.
d. Liftthecove
roffandsetitaside.
Figure 1 Release the cover latch.