Spectracom NetClock 9483 - Setting up a Static IP Address Via a DHCP Network

Note: Despite having entered an IP address, the information display will show
0.0.0.0 if NetClock could not detect an active link on the corresponding network
interface.
Note: About DNS: The Primary and Secondary DNS servers are set automatically
if using DHCP. If DHCP is not available, they can be configured manually in the
NetClock WebUI via the Network/General Setup screen.
The remainder of the configuration settings will be performed via the Web UI (accessed via an
external workstation with a web browser such as Firefox
®
or Chrome
®
). For more information,
see "The Web UI HOME Screen" on page15.
2.11.2.3 Setting Up a Static IP Address via a DHCP Network
To setup a permanent static IP address, after connecting NetClock to a DHCP network:
1.
Enter the IP address shown on the front panel information display of your NetClock unit
(NetClock 9483 only) into the address field of your browser (on a computer connected
to the NetClock network). If the network supports DNS, the hostname may also be
entered instead (the default hostname is "Spectracom"). The start screen of the NetClock
Web UI will be displayed.
2.
Log into the Web UI as an administrator. The factory-default user name and password
are:
Username: spadmin
Password: admin123
3.
Disable DHCP by navigating to MANAGEMENT > Network Setup. In the Ports panel on
the right, click the GEAR icon next to the Ethernet Port you are using. In the Edit Ethernet
Port Settings window, uncheck the Enable DHCPv4 field. Do NOT click Submit or Apply
yet.
4.
In the fields below the Enable DHCPv4 checkbox, enter the desired Static IP address, Net
mask, and Gateway address (if required). Click Submit.
For more information on network configuration, see: "Network Ports" on page59.
For subnet mask values, see "Subnet Mask Values" on page53.
5.
Verify on the front panel information display that the settings have been accepted by
NetClock.
6.
Enter the static IP address into the address field of the browser, and again log into the
WebUI in order to continue with the configuration; see: "The Web UI HOME Screen"
on page15.
2.11 Setting up an IP Address
CHAPTER 2 • NetClock User Reference Guide Rev. 16
49