2. Retrieving and displaying scan data collected and stored during standalone
operation.
Be sure to install the software (and any USB/Bluetooth communications drivers
as needed) prior to the first time you connect to the instrument.
When running DARWin SP make sure your instrument has a charged battery and
that it is powered and that the proper communications interface has been enabled. As
with standalone operation, the instrument requires approximately one minute to stabilize
before it will respond to communications from the software. Once communications have
been established, a brief initialization sequence follows and then your system is ready
for use.
For detailed information on how to use DARWin SP with your PSR Series
spectroradiometer, see the DARWin SP User Manual included with your instrument.
To Next Page
Loading...