7. CUSTOMIZING SETTINGS
Press DOWN to highlight SETTINGS.
Press ENTER to access the next screen, which
defaults to UNITS and LANGUAGE.
Press UP or DOWN to highlight the feature to be
changed and ENTER to access the next screen, or
highlight EXIT and press ENTER to return to
OPERATION.
7.1 CHANGING UNITS OF VISIBLE LIGHT
MEASUREMENT
AccuMAX provides users the capability of choosing
the default visible light unit of measure to either
foot-candles (fc), Lux, lm/ft
2
or lm/m
2
.
UV intensity units will autorange from µW/cm
2
to
mW/cm
2
to W/cm
2
.
Press ENTER to highlight the right column, then UP
or DOWN to change from fc to Lux.
Press ENTER to return to left column, DOWN to
highlight EXIT and ENTER again to access UNITS.
7.2 ADJUSTING CONTRAST
Press DOWN to highlight CONTRAST.
Press ENTER to access the next screen, where the
default contrast level is 48, which gives the best
display in most lighting environments.
This level can be changed to range from 42 to 55 by
pressing UP or DOWN. Press EXIT to save the
setting and return to the previous screen. NOTE: Any
changes to the contrast level will revert to default
level when the AccuMAX is shut off.
7.3 ADJUSTING BACKLIGHT
The screen BACKLIGHT intensity can be adjusted to
suit ambient light conditions and user preferences.
The meter is ACTIVE immediately after being turned
on or after pressing any button, and will go into
PASSIVE operation after a set time INTERVAL expires.
Press DOWN to highlight BACKLIGHT.
10
To Next Page
Loading...