Spectronics Spectroline AccuMax Series - Customizing AccuMAX Settings (Continued); Setting Active;Passive Operation Interval

7.3.1 SELECTING BACKLIGHT FOR ACTIVE AND
PASSIVE OPERATIONS
Press ENTER to access the next screen where
ACTIVE is highlighted.
Press ENTER, then UP or DOWN to change options
in the right column.
Press ENTER to save the setting and return to the
left column.
Press DOWN to highlight PASSIVE.
Press ENTER and then UP or DOWN to change the
BACKLIGHT setting in the right column.
Press ENTER to save the setting and return to the
left column.
7.4 ADJUSTING INTERVAL BETWEEN
ACTIVE AND PASSIVE OPERATIONS
Press DOWN to highlight INTERVAL, the length of
time the meter stays in ACTIVE operation before
reverting to PASSIVE.
Press ENTER again to access the right column to
set the length of time (60sec, 30sec, 10sec) between
ACTIVE and PASSIVE operations.
Setting NEVER keeps the BACKLIGHT level at the
ACTIVE brightness level continuously.
Press ENTER to save the setting and return to the
left column.
Press DOWN to highlight EXIT, then ENTER again
to return to OPERATION.
11