Spectronics Spectroline AccuMax Series - Installation and Setup of the AccuMAX Meter; Controls, Connectors, and Indicators; Direct Connection Method; Remote Connection with Water-Resistant Adapter

3. INSTALLATION
3.1 CONTROLS, CONNECTORS AND INDICATORS
The AccuMAX dual-sensor detector (XDS-1000) may be connected to the meter readout unit (XR-1000) by direct
connection or by remote connection via USB connector (see below). Either of these options allows a complete
transfer of information in digital form.
3.2 DIRECT CONNECTION
Attach detector by lining up USB connections and pushing together.
3.3 ATTACHING WATER-RESISTANT ADAPTER (REMOTE CONNECTION)
The AccuMAX XRP-3000 kit includes a custom 5 ft (1.5 m) USB cable (XCB-100) with a water-resistant sensor
adapter. The male USB connector port attaches to the top of the AccuMAX readout unit and the female port inside
the adapter attaches to the bottom of the sensor detector.
With sensors facing upward, align the arrows on the adapter to the detector. Gently expose the USB port inside
the adapter by flipping the rubber edge outward, then connect it to the USB port on the sensor detector. Note: To
ensure water resistance, make sure the two rows of ridges on the adapter are firmly in place within the grooves of
the detector.
UV-A sensor
Visible sensor
Dual-sensor detector
(XDS-1000)
Meter readout unit
(XR-1000)
Dual-wavelength
UV-A/visible sensor
detector
Water-resistant adapter
LCD window with numbers,
units, modes and system status.
Displays multiplexed data from
UV-A/visible output.
6