5
Operation
Front Panel Display and Controls
* Enter the Control/Setup Menu Mode by pressing
the LEFT and RIGHT arrow buttons at the same time.
Inspection
The SF-ExplorIR ™ unit has been thoroughly inspected and tested prior to shipment from the factory.
Nevertheless, it is recommended that the monitor be re-checked prior to use. Inspect the outside of the
enclosure to make sure there are no obvious signs of shipping damage. If damage is discovered, please
contact your supplier for assistance.
DISPLAY
SCREEN
ENTER
When in the Control/Setup Menu
Mode*, press to save a
displayed value
KEYPAD
When in the Control/Setup Menu
Mode*, use these buttons:
• To move the arrow (>) on the
display screen to the desired
function
• Scroll through data
• Change a function’s value
MONITOR ON
LIGHT (Green)
Flashes during
warm-up
SYSTEM FAULT
LIGHT (Yellow)
ALARM LIGHT (Red)
SILENCE / ESC
Press this button:
• To temporarily silence the
audible alarm
• Return to the previous
screen without saving data
Power ON/OFF
Toggle Switch
To Next Page
Loading...