Spectrum DSP M2 User Manual V1.1
The configuration menu system:
The configuration menu may be entered by pressing the MENU button.
When in the menu system, it may be navigated using the following touch strokes:
• Centre-right up/down swipes – Selects the individual menu item.
• Right-side up/down swipes – Opens and selects the menu item
• EXIT/* – Exits the menu system, returning to the main transceiver display. Pressing-
and-holding will save settings to EEPROM.
• PREV – scrolls the menu up.
• NEXT – Scrolls the menu down
• DEFLT – Sets the default value for the selected item.
• PWR – Prepares to shut-down press Confirm immediately to complete.
Important Notes:
• When in MENU mode AFG (e.g. the volume control.) is always active for left-side
up/down swiping.
• Whenever a menu item is changed the warning “Save settings using POWER OFF!”
will appear along the bottom of the screen to warn you that any changes that you may
have made will NOT be saved unless you power down the transceiver using the MENU
then PWR button.
• If you have made any changes while in the MENU system, when you exit the MENU
system the MENU label will be orange and display “MENU *” to warn you that you
should save the settings or power down using the PWR button to save any changes
that you might have made.
There are several separate menus within the menu configuration system:
• The MAIN menu. These are the more commonly-adjusted items with the labels in
YELLOW.
• The CONFIGURATION menu. These are less-frequently adjusted items used for
calibrating the radio's hardware with the labels in CYAN (e.g. light blue.)
• Display & Touch menu.
• CW Mode settings menu.
• Filter selections menu. Use this to preselect the filters to be available.
• Touchscreen via menu.
• System info menu.
• Debug/Exper. Settings menu.
• Credits.
This manual details the key menu settings, with the more obvious menus not needing
detailing. If you have any questions or suggestions, please send us an email.
P 29
To Next Page
Loading...
Need help?
General