Spectrum DX6i User Manual

Setting up Elevator Compensation
3. Go to Adjust List Menu.
Go to Mix 2, activate the mix
and select GEAR Æ ELEV.
On the Rate, leave the Down at 0% and change the Up to -20%.
Select the SW (switch) to the GEAR switch.
This mixes down elevator with the flaps to prevent the airplane from ballooning
when flaps are deployed. This value will have to be fine-tuned depending on the
amount of flap travel and the amount of up aileron setup for CROW.

Spectrum DX6i Specifications

General

Channels	6
Modulation	DSM2/DSMX
Model Memory	10
Transmitter Frequency	2.4GHz
Display	LCD
RF Power	100mW
Battery Type	4 AA batteries (not included)
Modes	Mode 1 and Mode 2