Radian Pro DX6i Setup
With the DX6i you can use flaps and CROW on the Radian Pro. This setup allows you to
use basic flaps or engage CROW with the DX6i. There are not enough mixes available on
the DX6i to allow for camber and reflex settings in addition to flaps and CROW;
however, these are not required to enjoy the Radian Pro.
The setup shown has the flaps operated by the Gear switch on the DX6i. When the flap
switch is in the up position and the gear switch is flipped, the flaps will deploy.
If the flap switch is in the down position and the gear switch is flipped, it will deploy
CROW.
CAUTION: When setting up the airplane with the airplane turned on,
you should unplug the motor or remove the propeller to prevent the
motor from accidentally going to full throttle, if throttle is selected when
setting up one of the mixes.
Setting up Dual Aileron
1. In the Setup List menu, go to the Wing Tail Mix.
Select DUALAILE to ACT (active).
Reversing
Throttle: normal
Aileron: reverse
Elevator: reverse
Rudder: reverse
Gear: normal
Flap: reverse
Setting up CROW
2. Go to the Adjust List Menu.
Go to Mix 1, activate the mix
and select GEAR Æ FLAP.
On the Rate, leave the Down at 0% and change the Up to -65%.
Select the SW (switch) to the FLAP switch.
This mixes the ailerons with the flaps for CROW. Changing the Up value will
change the amount of up aileron you will have when CROW is engaged.
To Next Page
Need help?
General
