SpeedTech Lights FLARE 12 - Flash Pattern Information; Flash Pattern List; Flash Pattern Shortcuts; About Flash Patterns

6 SpeedTech Lights, Inc © 2019
FLARE 12
HIDEAWAY
All rights reserved. No part of this Instruction Manual may be reproduced, distributed, transmitted, or otherwise shared in any form or by any means,
including but not limited to photocopying, recording, electronic delivery, .PDF reproduction, or any other means of reproducing all or any part hereof without
the express prior written consent of SpeedTech Lights, Inc, except for non-commercial purposes as permitted by United States copyright law. Customers
of SpeedTech Lights, Inc, may download and print this Instruction Manual for use with products sold to the customer by SpeedTech Lights, Inc. However,
no part of this Instruction Manual may be otherwise or subsequently reproduced, downloaded, disseminated, published, or transferred, in any form or by
any means, except with the prior written consent of SpeedTech Lights, Inc.
Flash Pattern List
• Steady Burn
• Single Flash 120FPM
• 3x4
• Single Flash Alternating
• Single Flash 150FPM
• Slow 3x4
• 3x2
• Fast 3x2
• Fast Single Flash Alternating
• Super Fast Single Flash Alternating
• Quad Flash 45FPM
• Alternating Steady Burn/Flash
• Random
• 3x3
• Slow 3x3
• Variable Speed Alternating
• Variable Speed
• Single Flash 75FPM
• 3 LED Rotation
• Double Flash 60FPM
• Single Flash 90FPM
• Slow Evens/Odds
• Steady Burn Odds. Single Flash Evens
• Steady Burn Evens. Single Flash Odds
• Quad Flash 60FPM
• Fast Even/Odds
• Single Flash 180FPM
• Quint Flash 60FPM
• Even/Odds
• Single Flash 210FPM
• 3x4 6x4
• Fast 3 LED Rotation
• Quad Flash 75FPM
• Single Flash 60FPM
Flash Pattern Shortcuts
• Hold for 3 seconds to toggle Steady Burn mode.
About Flash Patterns
• All STL LED products are equipped with a non-volatile memory which will recall the last ash pattern when the Light Bar is turned on.
• Set the ash pattern by pushing the Flash Pattern button on the Grand Control Box to cycle through the various patterns.
• If you are not using the Grand Control Box, follow the wiring diagram to identify the Flash Pattern wire to manually cycle through patterns.