Need help?Do you have a question about the SpeedyBee Bee 35 and is the answer not in the manual?
Details installation of aluminum standoffs and button head hex socket screws for the head part.
Instructions for inserting the O-ring into the antenna to secure it on the TPU antenna base.
Specifies mounting hole sizes for 20x20, 25.5x25.5, and 30.5x30.5mm flight controllers.
Details motor mounting hole distance of 12x12mm and recommends M2 (6mm) screws.
Provides recommended cable lengths for 25.5 AIO (52mm) and 20mm MINI (62mm) ESCs.
Identifies the location for SMA antenna installation on the mount.
Details the installation of the adjustable GPS mount with dimensions 12x16mm.
Information on the TYPE-C module and selecting the correct interface for FC connection.
Step 1: Install the aluminum alloy at the bottom position.
Step 2: Install the video transmitter antenna into the TPU antenna mount.
Step 3: Install the video transmitter into the aluminum bracket and secure it.
Suggests keeping ESC power cable around 100mm, referencing battery for actual length.
Details using M3 (14mm) button head hex socket screws for frame assembly.
Instructions for installing O3 Air Unit or RunCam Link using M2 screws.
Uses M3 (14mm) button head hex socket screws for bottom frame assembly.
Identifies M3 button head screws of lengths 8mm, 10mm, and 14mm for assembly.
Identifies M3 flat head screws of lengths 7mm and 9mm for assembly.
Instructions for mounting the T-antenna using specific M2 screws.
Specifies M2 (6mm) and M2 (7mm) button head hex socket screws for T-antenna.
Details M3 screws (8mm, 10mm, 20mm) and M3 nuts for the camera mount.
Note stating that this accessory needs to be purchased separately.
To Next Page
General