Spektrum AR635 - Specifications and Installation; AR635 Specifications; Receiver Installation; Antenna Polarization

EN
4
ReceiverInstallation
Make sure the receiver is mounted fi rmly and cannot move during aircraft
maneuvers or loosen in the event of harmonic vibration. We recommend
securing the receiver with high-quality, double-sided tape.
You can install the receiver longitudinally (inverted or upright) in a low
vibration position; however, the servo connector pins must always point
toward the front or rear of the aircraft.
ONLY install the receiver into your aircraft in the
following oriantations.
CAUTION: If AS3X is active and the receiver is not installed correctly,
the aircraft will crash.
Antenna Polarization
For optimum RF link performance, mount the antennas in an orientation
that allows for the best possible signal reception when the aircraft is in
all possible attitudes and positions. Orient the internal receiver antennas
perpendicular to each other.
AR635 Specifi cations
Type: .................................................................DSM2/DSMX AS3X receiver
Channels: ..........................................................6
Modulation: ......................................................DSM2/DSMX
Dimension: .......................................................(WxLxH): 22 x 56 x 14 mm
Weight: ..............................................................13.2 g
Input Voltage Range: .......................................3.5 to 8.5V
Resolution: .......................................................2048
Compatibility: ...................................................All DSM2/DSMX aircraft
transmitters