Spektrum AR710018
EN
Modes of Operation
DX7
If using the DX7, the following is recommended.
In system setup mode program AUX2 to GYRO and GEAR to AUX2, the
RevLimit will be controlled and adjusted via the AUX2 switch,
and all the target rpm’s will be adjusted using the GEAR channel travel
adjust.
Note: The Gyro Gain channel will plug into the AUX2 channel and the gyro
screen will be used to adjust the gyro gain (see the DX7 manual for more
detail on gyro gain settings).
In the travel adjust screen two values can be selected that will correspond
with the desired rpm. Note that two different rpms can be selected, or if
one value is programmed to zero, the RevLimit will be turned off when the
AUX2 switch is in that position.
Important: When calibrating the system the AUX2 channel must remain
at 100% in both directions.
The RevLimit target rpm is adjusted thru the Gear channel (channel 5)
output.
To Next Page
Loading...
Need help?
General
