Spektrum DX2S User Manual

7SPEKTRUM DX2S USER GUIDE
RECEIVER CONNECTION AND
INSTALLATION
Typical Electric Installation
Typical Gas Installation
USING THE ROLLING SELECTOR
The Rolling Selector is pressed to access functions and
rolled to select specific features or to change settings
orvalues.PressingandholdingtheRollingSelector
for more than 3 seconds returns the display to the main
screen.
The DX2S features one-touch programming utilizing a
Rolling Selector. The Rolling Selector has three functions.
1. PressingtheRollingSelector-enterstheselected
function.
2. Rolling the Rolling Selector - highlights function or
changes settings and values when selected.
3. PressingandholdingtheRollingSelectorformore
than 3 seconds from any screen - returns the display
to the Main Screen.
Programmingisveryintuitiveandalwaysstartswitha
press on the selector, then a roll, then a press, then a
roll and so on. Most find that within a few minutes they
are able to easily program their car without reading the
instructions; however, to realize the full benefit of the
programming it is recommended that the manual be read.
Most racers find it is most convenient to use their thumb
when making programming changes as this allows for
one-handed programming, even allowing the car to be
runinonehandwhilemakingprogrammingadjustments
with the other.
Rolling Selector
Futaba is a registered trademark of Futaba Denshi
Kogyo Kabushiki Kaisha Corporation of Japan

Spektrum DX2S Specifications

General

Brand	Spektrum
Model	DX2S
Category	Remote Control
Language	English