EN
22
FM Channel (Optional)
It is not neccesary to use this feature for many configurations, and may add
confusion when not required (a set of PID values of for each flight mode results in
up to 45 separate values which require separate tuning).
Only use this feature to tune for isolated problems, or for enabling SAFE features
in specific flight modes. You may enable or inhibit Stability mode (SAFE) for each
FM channel.
Flight mode set up in main transmitter menu
1. Select System Setup on DX and NX or Model Setup on iX ->
Flight Mode Setup
Assign a switch for the flight mode selection. See your transmitter manual
for more information about setting up Flight Modes on your transmitter.
2. Select System Setup on DX and NX or Model Setup on iX ->
Channel Assign
Link the functions by assigning the Flight Mode channel. Select any
auxillary channel that is not in use and assign it to Flight Mode.
Forward Programming Setup
1. Select Forward Programming -> Setup
Select FM Channel, assign the channel which was previously selected in
transmitter programming.
2. Select Forward Programming -> SAFE
®
-> Stability
Each
FM channel
within Forward Programming can have Stability (self
leveling/ SAFE) enabled or disabled. Take into account your
FM channel
switch position, then set Stability on or off as desired for that flight mode.
3. FM channel
have PID tuning options for each axis (pitch, roll and yaw).
4. Move the
FM channel
switch to the other positions; a setup screen will
appear for each mode. Set the Stability function on or off as desired and
tune the PID values for each
FM channel
as required.
To Next Page
Loading...
