EN
5
Installation
1. The FC6350HX Flybarless System must be attached to the airframe with
the servo connector facing either forward or aft. The side of the FC6350HX
facing the main rotor disc must be parallel to the rotor disc.
2. Use one mounting pad (SPMA3032) to secure the FC6350HX to the
airframe.
NOTICE: Do not connect the swash plate, throttle or tail rotor servos until
the servo frequency has been configured. Failure to do so may result in
damage to the servo and/or your model.
Optional DSMX Remote Receiver
An additional non-telemetry DSMX remote
receiver connected to the side port labeled
RX is recommended when flying models
with blades longer than 360mm.
For information on binding remote receivers
without a bind button, refer to the section
titled Binding with Second Remote Receiver.
IMPORTANT: Always ensure the remotes are connected to the transmitter
before flying the model. A solid orange LED on each remote receiver indicates
a successful connection.
Remote Receivers
The FC6350HX Flybarless System uses a SRXL2™ Telemetry Remote to
access Forward Programming as well as other Smart features. Connect the
4651T using the supplied cable to the RX/PRG port as shown.
4651T
FC6350HX
RX/PRG
RPM | X-BUS
FLYBARLESS SYSTEM
RX
To Next Page
Loading...
