EN
9
6. Select Back, and navigate to the Direction menu.
When you move the collective pitch stick up, the swashplate must respond
with the correct positive pitch action. Set the Direction in the Output Setup
menu to ensure a positive collective stick movement results in the correct
positive blade movement.
IMPORTANT: Do not change servo reversing in the transmitter’s servo
menu.
Left Side View
Select Back to return to the previous menu.
7. Select the Sub Trim menu. The swashplate servos move to the center
position. For each of the swashplate servos, use the sub trim adjustments
to ensure the servo horn is perpendicular to the servo linkage.
Adjust the linkages from the servo to the swashplate to ensure the
swashplate is level. Ensure the main blades are at zero degrees collective
pitch. If not, adjust the swashplate to main rotor grip linkage to acheive
zero degrees pitch.
Select Back
one to exit the
SwashplateOutput
Setup menu.
This image shows a neutral configuration set for
zero degrees of blade pitch.
90˚
90˚
To Next Page
Loading...
