Spencer Carrera Tec - User Manual

Questions and Answers

J
Joel SchmidtAug 2, 2025
What to do if the Sensor Lock fixing system is not powered, locked, or faulty on my Spencer Medical Equipment?
- M
  Michael RamosAug 2, 2025
  If the Sensor Lock fixing system on your Spencer Medical Equipment isn't powered, is locked, or seems faulty, first verify the power supply to the fixing system. If the issue continues, it may be that the stretcher is being used with a fastener that doesn't support automatic release; if so, request a compatible fixing system. If problems persist after these steps, remove the device from service and contact the service centre.
R
reynoldsadamAug 5, 2025
What to do if the stretcher is not correctly attached to the fixing system of my Spencer Carrera Tec Medical Equipment?
- J
  Jessica DanielsAug 6, 2025
  If the stretcher on your Spencer Medical Equipment is not correctly attached to the fixing system, and the cause is that the fifth wheel has not been properly inserted in the fixing system, position the stretcher properly and check that the fifth wheel enters the dedicated part on the fixing system. However, if the issue stems from wear or damage to the locking mechanisms' components, remove the device from service and contact the service centre.
B
Brian BarnesAug 10, 2025
Why are the leg unlocking levers difficult to operate on my Spencer Carrera Tec Medical Equipment?
- B
  bakerchristopherAug 10, 2025
  If the leg unlocking levers on your Spencer Medical Equipment are difficult to operate, it could be due to damaged moving mechanisms or lost connections between components. In either case, immediately remove the device from service and contact the service centre.
T
Tina BurnsAug 14, 2025
What to do if the stretcher does not release from the fixing system when operating the release lever on my Spencer Carrera Tec?
- F
  Frank BarkerAug 14, 2025
  If your Spencer Medical Equipment stretcher does not move from the fixing system when the release lever is operated, manually unlock the stretcher and finish unloading. Then, check the positioning of the magnet inside the fifth wheel holder and restore it to its original position. If this doesn't solve the problem, immediately remove the device from service and contact the service centre.
G
Gary LewisAug 18, 2025
Why don't the front legs lock when unloading my Spencer Carrera Tec Medical Equipment from the medical vehicle?
- D
  Don RobertsAug 19, 2025
  If the front legs of your Spencer Medical Equipment do not lock when unloading from the medical vehicle, it may be due to damaged moving mechanisms. Alternatively, the loading floor height might not be suited to the device. Adjust the loading floor height to meet the requirements. If the loading floor cannot be adjusted, remove the device from service and contact the service centre.
T
Teresa SchultzAug 23, 2025
How to set the stretcher in intermediate position if it is not possible on my Spencer Carrera Tec?
- S
  Stanley CastilloAug 25, 2025
  If you can't set the stretcher in an intermediate position on your Spencer Medical Equipment, first ensure that nothing is interfering with the moving mechanisms. Also, carefully follow the instructions to properly operate the levers. If the moving mechanisms are damaged, immediately remove the device from service and contact the service centre.
S
Shelby MirandaAug 27, 2025
What to do if there is damage to the structure of my Spencer Medical Equipment?
- S
  Steven RojasAug 27, 2025
  If there's damage to the structure of your Spencer Medical Equipment due to improper use, immediately remove the device from service and contact the service centre.