Spencer BOB - User Manual

1
User manual
BOB
Stretcher support
The device is manufactured in compliance with directive 2006/42/EC
Original version of the instruction manual
Warning
The information contained in this manual is subject to change without notice.
The Diagrams are inserted only for reference and may vary slightly from the actual device.
Spencer Italia S.r.l. assumes no responsibility for any errors contained herein or for damage, accidents or consequences connected with the supply,
performance or use of this manual
Prima emissione: 2016
Rev. 1: 22/11/2019
SPENCER ITALIA SRL a socio unico – Via Provinciale 12 – 43038 Sala Baganza (PR) - Italy
www.spencer.it | support.spencer.it - e-mail: info@spencer.it | service: service@spencer.it |Ph./Tel. +39.0521.541111
Quality System EN ISO 9001 – EN ISO 13485
1
User manual
BOB
Stretcher support
The device is manufactured in compliance with directive 2006/42/EC
Original version of the instruction manual
Warning
The information contained in this manual is subject to change without notice.
The Diagrams are inserted only for reference and may vary slightly from the actual device.
Spencer Italia S.r.l. assumes no responsibility for any errors contained herein or for damage, accidents or consequences connected with the supply,
performance or use of this manual
Prima emissione: 2016
Rev. 1: 22/11/2019
SPENCER ITALIA SRL a socio unico – Via Provinciale 12 – 43038 Sala Baganza (PR) - Italy
www.spencer.it | support.spencer.it - e-mail: info@spencer.it | service: service@spencer.it |Ph./Tel. +39.0521.541111
Quality System EN ISO 9001 – EN ISO 13485
SPENCER ITALIA SRLSPENCER ITALIA SRL – Via Provinciale n° 12
43038 Sala Baganza (PR) – Italy
EN
User manual
BOB
Stretcher support

Summary

Models

Intended Use

Reference Standards

Introduction

Use of the manual

Provides operator with necessary information for safe and appropriate use and maintenance.

Labelling and tracking control of the device

Details identification label on the device, including manufacturer, product, CE mark, serial/lot number.

Symbols

Explains symbols used in the manual and their meanings for safe operation.

Warranty and Support

General Warnings

User training

Emphasizes the importance of trained staff and reading the manual before any operation or maintenance.

Installers training

States installation must be done by qualified staff authorized by Spencer Italia S.r.l.

Product functionality

Forbids use other than described, mandates checks before use, and prohibits tampering.

Specific Warnings

Requirements of operators

Operators must be trained, qualified, and able to assess fixation integrity and report issues.

Residual Risk

Technical Data and Components

Technical data

Provides detailed specifications including length, width, height, extraction, sideways movement, and weight.

Components

Identifies and lists the various components of the stretcher support system.

Installation and Start-Up

Installation

Outlines critical steps for proper installation, including package verification and vehicle compliance.

Ambulance compartment check

Details checks for ambulance compatibility, ensuring space for support and movement in all directions.

Floor installation

Instructions for installing the device on the ambulance floor, emphasizing leveling, strength, and screw types.

Stretcher fastener installation and connection of Electric Pack (optional)

Details the installation of the stretcher fastener and the optional electric pack connection.

Electrical installation

Specifies power supply requirements, voltage, connection, and cable section for the device.

Instruction for Use

Sideways movement

Explains how to move the stretcher support sideways using red levers.

Extraction of the stretcher support (if available)

Describes the process of partially extracting the stretcher support for loading/unloading.

Turn on and off the courtesy light

Instructions for operating the courtesy light using the button on the front bumper.

Housing for immobilization devices

Details the compartment for storing devices like spinal boards or pick-up stretchers.

Cleaning and Maintenance

Cleaning

Provides guidelines for cleaning, including usable/unusable products and safety precautions.

Ordinary maintenance

Establishes a maintenance program, periodic testing, and record-keeping requirements.

Periodic maintenance

Mandates annual servicing by manufacturer or authorized center to maintain CE compliance and warranty.

Special servicing

States only authorized centers can perform special servicing operations; end user can replace spare parts.

Life span

Defines the device's average lifespan as 5 years, extendable with annual revisions.

Troubleshooting

How to return for servicing

Lists key points for returning equipment, including hygiene checks and disinfection procedures.

Accessories

Spare Parts

Demolition

Declaration of Conformity

Spencer BOB Specifications

General

Category	Medical Equipment
Material	Silicone, PVC
Volume	1600 ml
Oxygen Reservoir	Yes
Standard	ISO 10651-4
Type	Bag Valve Mask (BVM)