13
9.5 Electrical installation
The device is not electrically operated.
If it comes with electric pack (optional), its power connection is a connector placed behind the front bumper of the stretcher support which
shall be connected according to the procedures described in the previous paragraph.
WARNING:
- Carefully check the requirements for the power supply in the following table.
- The device needs to be connected to the electrical supply ensuring that it is powered also if the vehicles is turned off . The connection to
the power supply can be made only after the device has been properly fixed on the ambulance floor like described in the previous paragraph.
Power supply requirements
Insert the negative cable inside the negative line of the connection terminal
Insert the positive cable inside the positive line of the connection terminal
The minimum allowed section is 2 mm
2
Before you start using the stretcher support, carefully check that it works properly In accordance with the operating instructions described in
paragraph 10 and all remaining warnings of this manual.
To Next Page
Loading...
