5
Those who modify or have modified, prepare or have prepared the product in such a way that they no longer serve the purpose for which
they were intended, or no longer supply the intended service, must satisfy the valid conditions for the introduction onto the market.
Ensure that all the necessary precautions are taken in order to avoid the hazards that can arise as the result of contact with blood or
body fluids, when applicable.
Ensure that the fastener of the stretcher is properly installed on the stretcher support before starting to use the product.
Operating temperature: from 0°C to +50°C
Storage
The device must be stored indoors in a dry and clean place, about 100 / 150 mm off the ground. Avoid exposure to direct sunlight; It is
possible to stack up only a maximum of two supports, with their original cardboard box and wooden pallet in good condition. Stacking up
is prohibited if these conditions are not met.
Do not store the device underneath any heavy objects which could cause structural damage.
Store and transport the device in its original packaging. Failure to do so makes the warranty void.
Storage temperature: from -10°C to + 50°C
Storage Humidity: max 80%
Maintenance/cleaning
Spencer Italia S.r.l. disclaims any liability for any damage, direct or indirect, which is a result of improper use of the product and
replacement parts and / or otherwise of any repairs made by an entity other than the authorized Spencer service centres; this will also
invalidate the warranty.
The operator must always wear adequate personal protection such as gloves during all checking and maintenance procedures.
Establish a maintenance program and periodic testing, identifying an employee responsible for overseeing. The person to whom the
ordinary maintenance of the device is entrusted must ensure the basic requirements foreseen by the manufacturer in the user’s manual.
The frequency of inspection is determined by factors such as legal requirements, the type of use, frequency of use, environmental
conditions during use and storage.
Spencer Italia S.r.l. disclaims any liability for any damage, direct or indirect, that is the result of incorrect repairs or use of products made
by Spencer Italia S.r.l. Repairs must necessarily be carried out by an authorized Spencer Italia service centre, which in using original spare
parts will provide a quality repair service in strict accordance with the technical specifications given by the manufacturer. Spencer Italia
S.r.l. disclaims any liability for any damage, direct or indirect, which is a result of improper use of spare parts and/or otherwise of any
repairs made by an entity other than the Spencer service centres authorized to repair or make substitutions on this product and parts
and/or otherwise of any repairs made by an entity other than the Spencer service centres authorized to do so; the warranty will also be
invalidated.
Use only original components, spare parts and or accessories, approved by Spencer Italia S.r.l., in order to carry out any operation
without causing any alteration or modification to the device.
All maintenance and revision must be recorded and documented with the corresponding report for technical assistance; documentation
shall be maintained for at least 10 years from the end of life and must be made available to the competent authorities and/or the
manufacturer if requested.
Regulatory requirements
As a distributor or end user of products manufactured and/or marketed by Spencer Italia S.r.l., you are strictly required to have a basic
knowledge of any legal requirements applying to the devices contained in this supply that are in power in the final destination
Country (including laws and norms regarding technical specifications and/or safety requirements) of the goods and therefore you are
also strictly required to have the necessary knowledge to guarantee all aspects regarding the total conformity of the products to the
regulations in the relevant territory.
Promptly notify Spencer Italia S.r.l. (already during the first product enquiry) when requesting in details regarding any revisions to be
made by manufacturer in order to guarantee the conformity of the products to the territory’s legal specifications (including those
resulting from rules and/or norms of other kind).
Act, with all due care and diligence, and contribute to ensure conformity to general safety requirements of all devices marketed in the
territory, by providing final users with all necessary information for carrying out periodical checks on their devices, exactly as specified in
the relevant user’s manual.
Actively contribute to safety checks on product sold, by communicating any relevant risk analysis information to the manufacturer.
The distributor or final user is aware that in the event of any failure to conform to the above mentioned requirements you will be
deemed fully responsible for all damages that might occur. Therefore Spencer Italia S.r.l. expressly disclaims any responsibility and/or
liability for your non-compliance with the present regulatory provisions.
General warnings
The user must carefully read not only these general warnings, but also those listed below.
It is not foreseen that the use of the device is prolonged beyond the time necessary for the first responders to the complete the stages of
transport to the nearest rescue point
Follow the procedures and protocols approved by the internal organization for maintenance and disinfection procedures of the product.
To Next Page
Loading...
