3
1. MODELS
The standard following models can undergo change, revision and implementation without any notice.
BOB – STRETCHER SUPPORT WITH SIDEWAYS MOVEMENT
BOB – EXTRACTABLE STRETCHER SUPPORT
BOB – EXTRACTABLE STRETCHER SUPPORT WITH SIDEWAYS MOVEMENT
BOB SLIM – SIDEWAYS MOBAVLE STRETCHER SUPPORT SLIM
Optionals like ramp, led lights, cigarette lighter or others, could generate variants of the products and of the product code.
2. INTENDED USE
BOB is a stretcher support to be permanently installed inside an ambulance to facilitate loading and unloading procedures of the stretcher.
3. REFERENCE STANDARDS
As a distributor or end user of products manufactured and/or marketed by Spencer Italia S.r.l. you are strictly required to have basic
knowledge of any legal requirements applying to the devices contained in this supply that are in power in the goods final destination
Country (including laws and norms regarding technical specifications and/or safety requirements) and therefore you are strictly required
to have the necessary knowledge to guarantee all aspects regarding the total conformity of the products to the regulations in the relevant
territory.
Directive of the European Parliament and of the Council of 17 May 2006 on machinery
Medical vehicles and their equipment - Road ambulances
Patient handling equipment used in road ambulances - Part 5: Stretcher support
4. INTRODUCTION
4.1 Use of the manual
This manual is intended to provide the operator with all the necessary information for its safe and appropriate use as well as adequate
maintenance of the device
Note: The manual is an integral part of the device. It must be kept for the duration of the device and must accompany the device in case of
change of ownership or destination. If the operating instructions received relate to products not received, you must immediately contact the
manufacturer before use.
The Spencer product manuals can be downloaded from the website www.spencer.it/en/emergency-medical-solutions/user-manuals or by
contacting the manufacturer. Exceptions are items whose essentiality for reasonable and predictable use is such as to make it unnecessary
to prepare instructions in addition to the following warnings and directions on the label.
Regardless of the level of experience gained in the past with similar devices, it is recommended that you carefully read this manual before
installing, operating or using the product or any maintenance
4.2 Labelling and tracking control of the device
Each device has got an identification label positioned on the device itself and/or on its box, which includes identification data about the
manufacturer, the product, the CE mark, the serial number (SN) or lot number (LOT).
It must never be removed or covered.
The label on the device has the following informations:
In case of damage or loss, request a duplicate from the manufacturer. Failure to do so will interrupt the validity of the guarantee as the
device can no longer be traced.
To Next Page
Loading...
