8000M Mixer/Mill
Page 16 of 27 SPEX SamplePrep LLC January 2010
7.0 ACCESSORIES: GRINDING/MIXING VIALS
(If not included in your order, these are available for purchase at additional cost.)
8001 Hardened Steel Vial Set
Vial size 2 1/4 in. dia. x 3 in. Vial body and cap liner of
hardened tool steel. Set includes screw-on cap with O-
ring to allow wet or dry grinding/ mixing, two 1/2 in. and
four 1/4 in. steel balls. Grinding load 3–10 ml; mixing
load approx. 25 ml.
8003 Alumina Ceramic Vial Set
For dry grinding/mixing. Vial size 2 1/4 in. diameter x 2
3/4 in. High purity 99.5% alumina ceramic vial body and
two slip-on caps with one 1/2 in. ball; set includes eight
corprene gaskets. Grinding load 2–8 ml; mixing load
approximately 20 ml.
8015 Clamp for 8003
Clamps permit slurry grinding in 8003 vials; sold in pairs.
One pair required for each 8003.
8004 Tungsten Carbide Vial Set
For wet or dry grinding/mixing. Vial size 2 1/4 in.
diameter x 2 1/2 in. Tungsten carbide-lined body, two
screw-on tungsten carbide-lined caps, two 7/16 in.
tungsten carbide balls, eight corprene gaskets. Grinding
load 3-10ml, mixing load approximately 25ml.
To Next Page
Loading...