Battery Charging
To extend the life of your battery please follow these guidelines.
• Charge the battery immediately after each use. Don’t leave your
battery in a at state for extended periods.
• Don’t leave the battery plugged into the charger too long after it is
fully charged.
Your battery will take 8 to 15 hours to be fully charged. The LED light on
the charger pack will turn green when the battery is fully charged. If LED
stays red, the charging process is still continuing. A fully charged battery will
provide approximately 2-3 hours of use. Higher ball speed requires more
power and therefore will drain the battery faster.
Battery Model
Plug the battery charger into a electrical outlet and then insert battery
charger cable into the socket labeled CHARGER on the control panel of your
machine.
Hybrid Power / Battery Model
Plug the battery charger into an
electrical outlet and then connect the
battery charger cable to the battery
cable port (as pictured).
Installing or Replacing
the Battery
If you need to install or replace your battery you can do so by opening the
battery cage. To access the battery cage please follow these steps:
1. Remove wheel that covers the access panel to the battery cage.
2. Unscrew the four screws of the access panel.
3. Connect the battery to the terminals inside the battery cage - connect
the red wire to the red terminal and the black wire to the black terminal
4. Insert the battery into the battery cage. Ensure you put the battery
terminals to the top left side when you insert the battery into the cage.
7
To Next Page
Loading...
