2-LINE = 2-Line Oscillation
The 2-Line oscillation setting serves balls to two preset locations on the
court allowing a user to practice alternating forehand and backhand shots.
Placement of these alternating shots can be dened by using the w1-w2
setting as described in the w1-w2 button section.
After the machine has been set to the 2-line oscillation mode, the user can
press VERTICAL to make the machine set to a 2-LINE HORIZONTAL AND
VERTICAL OSCILLATION.
VERTICAL = Vertical Oscillation
The vertical oscillation mode serves a combination of high balls and low
balls. The machine will serve balls at two height levels dened by the h1 and
h2 settings.
If machine has been in the random horizontal oscillation mode, pressing
this button will set the machine to RANDOM HORIZONTAL AND VERTICAL
OSCILLATION mode. If the machine has been in 2-line oscillation mode,
pressing this button will set the machine to a 2-LINE HORIZONTAL AND
VERTICAL OSCILLATION mode.
In all vertical oscillation modes, pressing the SPEED button a second time
will set the speed level for the second height level (h2).
MANUAL = Manual Mode
Pressing the MANUAL button will set machine back to manual mode without
oscillations.
Spinshot Remote Watch
The remote watch can be used to start and stop the ball feed and select
drills. A long click (over two seconds) will start and stop the ball feed. A
short click of the button selects the drill number equivalent to the number of
clicks. ie, 2 clicks = Drill #2, 12 clicks = Drill #12.
The remote watch will enter sleep mode after 30 seconds of inactivity. When
the machine power is on, pressing the remote watch button to wake it up. If
the LED is not lit up on the remote please move closer to the machine and
check again.
6
To Next Page
Loading...
