Height
Set the ball height from the lowest position of 1 to the highest position of
50. If you set Height value to “R”, the machine will throw balls in a random
vertical angle and also random speed. The Feed rate will be set at 6.
Speed
Set the ball speed value from 1 to 20.
Feed
Feed rate ranges from 1 to 10. At the rate of
10 a ball will be fed at a rate of one ball per
second.
Save
After selecting the desired values, press the
Save button on the top right corner of the
display. The machine will save the settings on
the phone and also download settings to the
connected machine. The machine will switch to
the new saved settings directly after the user
has pressed the Save button.
Restore Default Settings
To restore a custom drill back to factory default
settings, go to the drill edit screen and select
Restore to Default Settings from the drop down
menu.
Manual Mode
Press the Manual Mode button to manually
control the horizontal placement, spin, height,
speed and feed rate of the balls.
Once Manual Mode is selected the values can
be edited using the respective buttons.
For full details on settings for Horz, Spin Height,
Speed and Feed - see Editing Custom Drills
section above.
12
To Next Page
Loading...
