MOTOR T and B TRIP SWITCHES
The MOTOR switches protect the electronics and motors. When activated,
the switch pops out approximately 6 mm. In the event the switch is
activated, turn off the power and push the switch back in. Once the
throwing wheels have stopped moving, check for any balls jammed inside
the machine and remove them. Turn the power back on to resume normal
operation.
The activation of the motor switch can be caused by excessively dirty or slick
ball throwing wheels, which can prevent the wheels from properly gripping
the balls. Cleaning the ball throwing wheels as described in the Maintenance
and Cleaning section will restore proper performance.
PLAY / PAUSE BUTTON
The PLAY / PAUSE button will set the machine to start or stop. Every time
you switch the machine power ON, and once the initialization is completed,
you need to press the PLAY button to start the machine. Your machine will
not accept any setting changes after powering it on until you have pressed
the PLAY button.
DRILL BUTTON
The DRILL button is used to select the machine’s preprogrammed drills. You
can either use the factory set programmed drills, or customize new drills
using the Drill Maker App on your phone. Please refer to the Drill Maker
App section for how to use the App. After pressing the Drill button, press
+ or – to choose the drill number to play. Press the PLAY button to start the
ball feed.
UP [ + ] and DOWN [ - ] BUTTON
The UP and DOWN buttons are used to adjust the manual setting
parameters, or select the Drill number. Before clicking either button, select
the setting to be adjusted. The manual settings include ball SPEED, ball
HEIGHT, FEED frequency, SPIN level, h1-h2 and w1-w2. Please read the
Manual Settings section for more details about these setting types.
3
To Next Page
Loading...
