Spinshot Pro - Operating Your Tennis Ball Machine; Starting Your Machine

Operating Your Tennis Ball Machine
Your tennis ball machine can be operated via the machine’s Control Panel
or the Spinshot Remote Watch (sold separately).
Starting Your Machine
MACHINE POSITION ON COURT
The standard position for the ball machine is the
center of the baseline at the far end of the court.
TENNIS BALLS
Fill the ball hopper with up to 120 tennis balls.
Do not overll the hopper.
POWER
Use the Power switch to turn on the machine.
The machine will perform an initialization sequence, turning left and right.
The service wheels will begin to spin.
After the initialization sequence, reposition the machine so it is
centered.
This will ensure balls are delivered the full width of the court
when the Oscillator function is used.
After a few seconds the feeder tray will begin to rotate and the ball delivery
will start.
If the balls are going too far to one side, turn the machine slightly to the
other side.
2