CONTROL PANEL SETTINGS
Speed
Set the ball speed value from 1 to 10.
Speed 1 is approximately 30km and speed 10 is
approximately 110km.
Feed
The Feed rate sets the interval between the
delivery of each ball. Feed rate 1 is the slowest
and 10 is the fastest. At Feed rate 10 a ball will be
delivered approximately one ball every second.
Spin
Turning the dial towards “Top” will add topspin, or
turning it towards “Back” will add backspin / slice.
For a ball with no spin select FLAT.
A high level of either topspin or backspin will slow the ball speed. To increase
ball speed reduce the amount of spin on the ball.
Ball spin can also affect the ball height. You may need to adjust both height
and spin to achieve the desired ball delivery.
Oscillator
Switch the Oscillator on to deliver balls across the full width of the court.
When the Oscillator is turned off the balls will be delivered to a constant point
determined by the direction the machine is facing.
Height
Use the Height toggle switch to adjust the height (trajectory) of the ball.
Ball spin can also adjust the height of the ball. You may need to adjust both
height and spin to achieve the desired ball delivery.
3
To Next Page
Loading...
