Spirax Sarco UTM20 Series - Wiring the Transmitter; Installing the MicroSD Card; Connecting the USB Cable

IM-P505-02-US Issue 1
40
UTM20 Series Ultrasonic Transit-time Flowmeters
8.17 Installing the MicroSD Card
WARNING
In a hazardous location where explosive gas or dust is present, disconnect the power before
opening the enclosure and inserting or removing the microsd card. After the card is inserted
or removed, close the enclosure before reapplying power.
1. In all locations, turn off power to the unit.
2. Remove the enclosure cover.
3. Put your finger in the groove of the tray and slide the tray downward. The tray springs open.
Fig. 46
4. Insert the MicroSD card.
5. Slide the cover up to close.
6. Replace the enclosure cover.
8.18 Connecting the USB Cable
Use a USB cable when connecting a UTM20 meter to a computer with SoloCUE® Flow Device
Manager software.
WARNING
Do not use the mini usb port in a hazardous location where explosive gas or dust is present.
Do not open the transmitter while powered if water or spray could contact electronics or interior.
1. Open the enclosure cover.
2. Connect the USB cable to the mini USB port, aligning the pins in the cable with the holes in the port.
3. Program the transmitter.
4. Remove the USB cable and close the enclosure cover.