Spirax Sarco UTM20 Series

To Next Page

To Previous Page

IM-P505-02-US Issue 1

UTM20 Series Ultrasonic Transit-time Flowmeters

Code Description Correction

S94 TEMP #2 LOW Temp #2 is below low alarm setting

Check fluid temperature and RTD

#2 Check alarm settings for Aux

Output #2

S95 TEMP #2 HIGH Temp #2 is above high alarm setting

Check fluid temperature and RTD #2

Check alarm settings for Output #1

S96 TEMP #2 HIGH Temp #2 is above high alarm setting

Check fluid temperature and RTD #2

Check alarm settings for Output #2

S97 TEMP #2 HIGH Temp #2 is above high alarm setting

Check fluid temperature and RTD #2

Check alarm settings for Output #3

S98 TEMP #2 HIGH Temp #2 is above high alarm setting

Check fluid temperature and RTD

#2 Check alarm settings for Aux

Output #1

S99 TEMP #2 HIGH Temp #2 is above high alarm setting

Check fluid temperature and RTD

#2 Check alarm settings for Aux

Output #2

Informational Events Codes

Information events are only displayed in the ALARM HISTORY and not on the Home Screen

Code Description

I01 POWER ON Power on or rebooted

I11 ZERO Meter zeroed

I12 FACTORY CALIBRATION Calibration changed from Field to Factory

I13 FIELD CALIBRATION Calibration changed from Factory to Field

I21 FIRMWARE CHANGED Firmware updated

I31 FLOW TOTAL RESET Flow total reset to zero

I41 NO SD CARD MicroSD card not installed

Spirax Sarco UTM20 Series - Page 79