Spirent C1 - Spirent C1 and C2 Admin Commands

Spirent C1 and C2 Installation Instructions
Using Authenticate Mode (optional)
Spirent C1 and C2 Installation Instructions | 33
PN 71-008959 Rev A April 2020
Table 7. Spirent C1 and C2 Admin Commands
Command Description
activate [[<deviceName>]<ipaddress>
<netmask> <gwaddress>] | [dhcp] | [ipv6
[<deviceName>] <ipv6addres>
<ipv6gwaddress>]
Save and activate the network configuration
authenticate [on|off|reset] Enable | Disable | Reset authenticate mode
console <vm name> Connect to a VM's console
date [MMDDhhmm[[CC]YY][.ss]] Show or set the date. e.g. date 01312359
dns <add> <address1> <address2>|<delete> Set the static DNS servers
exit Exit
gwaddress <address> Change the gateway address for the device
help List all commands
hostname Display or change the system hostname
ipaddress <address> Change the IP address for the device
ipv6address <address> Change the address for the IPv6 device
ipv6gwaddress <address> Change the gateway address for the IPv6 device
launcher Relaunch cookies
listvms Show any running virtual machines
logout Log out
macaddress Display the MAC address
mode <static|dhcp> Set to use either dhcp or static mode
netmask <address> Change the netmask for the device
network Show the current network settings
ntp Display or change the ntp settings
password Change the password
ping <ipaddress> Ping an IP address